This document does not contain any export-controlled information.
Installation
11
427-0108-00-10 - Revision 100 - December 2020
In the DNA Discover List, verify that the camera's status is
Authenticated
.
3. Change the camera’s IP address.
Right-click the camera and select
IP Setup
.
In the
DNA - IP Setup
window, clear
Use DHCP
and
specify the camera's
IP address
. You can also specify
the
Mask
(default: 255.255.255.0) and
Gateway
. Then,
click
Update
, wait for Ok status to appear, and then
click
Close
.
To manually specify the camera's IP address using the camera’s web page:
1.
2. On the
, click
System Settings
, and make sure the
4. Click
Static
IP addressing and then manually specify the camera's
Hostname
,
IP address
,
Netmask
,
and
Gateway
.
You can also specify the
DNS Mode
,
Name Servers
,
MTU
(maximum transmission unit), and
Ethernet
Speed
.
5. Click
Save
. Applying any changes on the Network page requires rebooting the camera.
2.6
Mount and Connect the Camera
Be sure to have the required accessories and tools available.
If using the CB-WLBX-G4 Wall & Surface Mount Kit with junction box, install it according to the installation
guide for that accessory. Install the power and network cables in the junction box so that they are
accessible when mounting the camera. If using other mounting hardware, install the mounting hardware
for the camera according to instructions.
To mount the camera directly on a wall or ceiling and
connect it:
1. Attach the mounting template sticker onto the wall or ceiling
where you are mounting the camera.
2. Drill six anchor holes according to the template.
3. Hammer the six plastic anchors into the drilled holes.
4. If the
is going to exit from the rear, drill a hole
in the center of the mounting template for the cable.
The system cable can exit either from the side of the
camera's mounting bracket or through the hole in the back
of the mounting bracket.
Rear Cable Exit
www.
.com
1.800.561.8187
