48
7. IDE Hard Disk Installation
Usually, the unit comes with one hard-disk drive installed in compartment HD 1, which is default-configured
as a master. The jumper settings of the installed hard-disk drives for the unit and compatible drives which
can be used with this unit are listed in the table below. To install two hard disk drives in compartment HD 1
and HD 2, please take the following steps.
The jumper settings of hard-disk drives for the system
Location Jumper
IDE 1
Compartment HD 1
Master
IDE 2
Compartment HD 2
Master
7.1 Built-in hard disk
1.
1. Unscrew all the mounting screws on the
mobile rack of the unit and detach it.
2.
3.
2. Carefully lift the mobile rack to a vertical
position.
3. Unscrew the secured screws to detach
the hard disk rack.
4.
5.
4. Setting the jumper of your hard disk
driver. The way to set the jumper of the
drive varies between manufacturers;
please refer to the instructions on the
driver to set the jumpers in the master
position.
5. Place the hard disk in the rack.
