FMS-2530 Tabletop Ultrasonic Scaler V.1
3
Section 1: Safety Precautions
Prior to the installation and start-up of the ultrasonic scaler, please read the instructions provided here.
1.1 Precautions for All Systems
Do not place the ultrasonic scaler on or next to a radiator or any other heat source. Excessive heat may
damage the ultrasonic scaler’s electronics. Place the ultrasonic scaler in an area where air is free to circulate
on all sides and beneath it. Do not cover the vents on the rear panel.
The ultrasonic scaler is portable, but must be handled with care when moving.
Equipment and dental water supply maintenance is strongly recommended. See Section 12: System
Maintenance And Care.
Turn off the master shut-off valve for the water supply every night before leaving the office.
The use of an in-line water filter is recommended.
Use the device for the intended purpose only. The ultrasonic scaler must be used by qualified and
trained personnel, in a medical/dental facility.
This device can only be properly grounded when the equipment is connected to a receptacle marked
Hospital Only or Hospital Grade. This device’s power supply is double insulated.
1.2 Precautions for Ultrasonic Prophylaxis Procedures
‧
Before first use, clean, disinfect and sterilize new or repaired instruments you wish to use with the
ultrasonic scaler.
‧
Always examine the unit and ultrasonic tips before commencing treatment. A damaged ultrasonic scaler
or damaged tip should not be used.
‧
Ultrasonic tips that have been bent, damaged, or reshaped are susceptible to in-use breakage and should
be discarded and replaced immediately.
Retract the lips, cheeks and tongue to prevent contact with the ultrasonic tip whenever it is placed in the
patient's mouth.
