F R O N T C O N S O L E
C H A P T E R 3
The
VHF+
button will swap between the typical HF bands and any configured transverter bands (see
the description of the XVTRs Form on page 121). The VHF band buttons work in the same way, but for
the frequencies within the transverter frequency range.
(6) Mode Selection
Figure 37: Mode Selection
The Mode Selection controls allow you to change the selected demodulation routine. Changing modes
will select the last frequency and filter used for that mode. Additionally, it will display the (configurable)
filter settings available for that mode (see Figure 39 below) and the appropriate mode specific controls
on the front console (see page 44). Following is a list of the available modes:
LSB:
Lower Side Band
USB:
Upper Side Band
DSB:
Double Side Band
CWL:
CW
L
ower Side Band
CWU:
CW
U
pper Side Band
FMN:
Frequency Modulation (FM) Narrow
AM:
A
mplitude
M
odulation
SAM:
S
ynchronous (PLL)
A
mplitude
M
odulation
SPEC:
Spec
trum mode (DC IF, max bandwidth determined by the selected sampling rate)
DIGL:
Dig
ital
L
ower Side Band (Enables VAC if VAC Auto Enable is engaged, see page 74)
DIGU:
Dig
ital
U
pper Side Band (Enables VAC if VAC Auto Enable is engaged, see page 74)
DRM:
D
igital
R
adio
M
ondiale (requires licensed external demodulator software not available
from FlexRadio Systems; Enables VAC if VAC Auto Enable is engaged, see page 74)
Hotkeys are available in the Setup-Form, Keyboard Tab to cycle through the various modes using the
keyboard (see page 104).
[The rest of this page has been left blank intentionally]
41
2003-2009 FlexRadio Systems