Flexim FLUXUS WD100, User Manual

Page: 10 / 106

FLUXUS WD100, WD200 2 Handling
10 UMFLUXUS_F5WDV1-1EN, 2016-04-08
2 Handling
2.1 First Inspection
The measuring instrument has already been tested thoroughly at the factory. At delivery, proceed to a visual control to
make sure that no damage has occurred during transportation.
Check that the specifications of the measuring instrument delivered correspond to the specifications given on the pur-
chase order.
The type and the serial number of the transmitter are shown on the nameplate. The transducer type is printed on the trans-
ducers.
2.2 General Precautions
FLUXUS is a precision measuring instrument and has to be handled with care. In order to obtain good measurement re-
sults and avoid damaging the measuring instrument, it is important that great attention is paid to the instructions given in
this user manual, particularly to the following points:
• Protect the transmitter from shocks.
• Keep the transducers clean. Manipulate the transducer cables with caution. Avoid excessive cable bend.
• Make sure to work under correct ambient and operating temperatures. The ambient temperature has to be within the op-
erating temperature range of the transmitter and the transducers (see Technical Specifications).
• Observe the degree of protection (see Technical Specifications).
2.3 Cleaning
• Clean the transmitter with a soft cloth. Do not use detergents.
• Remove traces of the coupling compound from the transducers with a soft paper towel.
Attention! On the display of the transmitter and the window of the front plate (inside and outside) are protection
films. Remove these protection films before using the transmitter.