CHE 2-28 R SDS-plus
19
Chiselling
1. Insert chisel.
2. Move rotary knob for operating mode
to the symbol.
3. Turn chisel into the required position.
4. Move rotary knob for operating mode
to the symbol. Ensure button is locked!
5. Swivel the auxiliary handle into the
required position.
6. Insert mains plug.
7. Grip electric power tool with both hands
and assume working position.
8. Switch on the power tool.
9. When chiselling, gently press electric
power tool forwards to prevent it from
jumping.
10. After working, switch off the power tool.
11. Pull out the mains plug.
Other information
– The use of “sharp” insertion tools
increases performance and the service
life of the electric power tool.
– After work, clean the electric power tool
and store in the carrying case in a dry
location.
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Cleaning
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
dependent on the material and duration of
use.
Regularly blow out the housing interior and
motor with dry compressed air.
Carbon brushes
The electric power tool features cut-off
carbon brushes.
When the cut-off carbon brushes reach their
wear limit, the electric power tool switches
off automatically.
NOTE!
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
When the power tool is being used,
the carbon brushes can be seen sparking
through the rear air inlet apertures.
If the carbon brushes are sparking
excessively, switch off the electric power
tool immediately. Take your electric power
tool to a customer service centre authorised
by the manufacturer.
Gears
NOTE!
Do not loosen the screws on the gear head
during the warranty period. Non-compliance
will deem the guarantee obligations of the
manufacturer null and void.
The electric power tool has grease
lubrication. Have the grease changed/
topped up by a customer service workshop
authorised by the manufacturer.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
If the power cord of the electric power tool
is damaged, it must be replaced with
a specially prepared power cord
(attachment type X). This power cord is
available from FLEX customer service.
Spare parts and accessories
Other accessories, in particular insertion
tools, can be found in the manufacturer’s
catalogues.
Exploded drawings and spare-part lists
can be found on our homepage:
www.flex-tools.com
