3.2
LIGHTING THE STOVE MANUALLY VIA THE CONTROL VALVE
3.2.1
These products can be operated manually by using the buttons directly
on the stove control in addition to the handset (should the need arise).
3.2.2
To operate the stove press and hold the “power” button as shown below
in figure 18 for two seconds, release as soon as the red indicator light
shown in figure 18 illuminates. The burner will then start its
ignition sequence and light to the maximum heat input level.
For most
efficient performance leave the stove on high when lighting from
cold for ten minutes. If the flames are extinguished for any reason
do not attempt to light the appliance for at least 3 minutes.
Fig. 18
3.2.3
To reduce the heat input, press and release the (-) button to lower the
heat input level one step at a time. Pressing the (-) button continuously
will move the heat input level to the minimum.
3.2.4
To increase the heat input level, press then release the (+) button to
increase the heat input level one step at a time. Pressing the (+) button
continuously will move the heat input level to the maximum.
3.2.5
To turn the stove off, press the power button and the burner will stop.
3.2.6
19
Indicator light
Power isolation switch
Battery compartment
cover opening lever
Battery
compartment
cover
Power button
Increase flame
Decrease
flame
If you are not intending to use the stove for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the “0” position
away from the “1” position) on the valve itself, which is located
under the stove on the top left of the control valve.
