Flashforge Guider 3, User Manual

Page: 22 / 56

The cleaning method can be viewed by clicking the [Clean the clogged nozzle] on the
maintenance screen. Please operate following the instructions on the screen.
6.2.2 Clogged Nozzle Cleaning
6.3 Platform Replacement
< Maintain
Method 1: Preheat the extruder, and heat the extruder to the required temperature
of the material used. Pull out the filament guide tube, press the handle, pull out the
filament, and insert the unclogging pin tool into the nozzle for unclogging.
Clean the clogged nozzle
20
1/2
The replacement method can be viewed by clicking the [How to Install a Glass
Platform?] on the maintenance screen. Please operate following the instructions
on the screen.
6.3.1 Glass Platform Replacement
Note: After the glass platform and flexible steel plate platform are exchanged,
the extruder height must be calibrated.
Note: The screws may become stripped after long-term use. If so, the spare screw
holes on both sides can be used.
< Maintain
After the flexible steel plate is removed,
press the rear edge of the glass against
the positioning block, lay it flat on the
build platform, install the hand screw bolt
to the front end of the platform, and then
rotate the hand screw bolt clockwise to
clamp the glass platform.
How to Install a Glass Platform？
1/3