Flashforge Guider 3, User Manual, Page: 16 / 56

1. Please remove the camera cover before using the camera;
2. Turn on the camera switch;
3. After the equipment is connected to FlashPrint, the real-time videos and images can
be viewed in the FlashPrint - [Multi-Machine Control].
1. If the flexible steel plate platform is used, after printing is completed, directly lift the
handle to remove the flexible steel plate and bend the platform plate to remove the
model;
2. If the glass platform is used, after printing is completed, directly remove the model
with a scraper.
When using the flexible steel plate platform,
remove the model and put the platform plate
back into the equipment. Operate as follows:
1. Hold the rear end of the flexible
steel plate against the positioning
blocks on the left and right edges of the
platform (note that it is inserted into the
inside of the positioning blocks);
2. The platform will be automatically adsorbed
and installed on the platform.
4.4 Camera Connection
When removing the model from the build plate, please pay attention
to the need to wait for the platform to cool down before operating.
At this time, you can check the temperature icon on the status bar of
the screen to confirm the platform temperature. The green icon
indicates that the platform temperature is lower than 50℃, which is
the appropriate state for safe operation. The matching gloves can be
used when removing the model. In the meanwhile, pay careful
attention to the high temperature of the equipment.
4.5 Model Removal After Finishing Printing
WARNING
Glass Platform Flexible Steel Plate Platform
14