ReteMatic™ Head Unit
IP-RMH1
Installation and Configuration manual
11
CONFIGURATION VIA WEB INTERFACE
The ReteMatic Head Unit can be configured by means of an internet browser through its
Web Interface
In order to access the Web configuration pages, it is necessary to know the unit’s IP address and to setup
the PC to properly connect to it (e.g. through an Ethernet cable). Units that have not been previously
configured have the default IP address
192.168.249.69
. Therefore, the PC used to access the unit must be
configured with an IP address in the range 192.168.249.x (with x different from 69) and network mask
255.255.255.0.
Open a Web browser and type the IP address of the unit in the address bar. The browser must have the
JavaScript functionality enabled in order to make the Web application work properly.
A
UTHENTICATION
P
AGE
It is necessary to authenticate the user before the Web pages are accessible. This page prompts the user
to enter either the configuration password to access the ordinary Web pages (the password will be by
default “retematic”) or the factory reset password to perform a factory reset.
By default, the session expires after five minutes if the Web pages are not accessed.
In most of the Web pages there is a log-out button and a link to close the session manually.
Figure 3 - Web interface - Authentication page
