FISNAR F1300N.2, Operating Manual, Page: 25 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 25 - F1300N.2 Rev 01
5.
Insert the electrical connector on the Z-Axis drive assembly into the “Safety” port on the
back of the machine.
6.
Connect pneumatic tubing marked “Cylinder In” on the Z-Axis drive assembly to the
“Cylinder In” port on the back of the machine.
Connect pneumatic tubing marked “Cylinder Out” on the Z-Axis drive assembly to the
“Cylinder Out” port on the back of the machine.
7.
Connect the foot pedal switch to the port on the back of the machine.
This step can be ignored if the controls on the front of the machine are being utilized or if
a remote operation box is being used.
8.
Connect the shorted EXT. Control plug provided in the accessories bag, into the
“EXT Control” port on the back of the machine.
This step can be ignored if a remote operation box is being used.
9.
Connect air hose from compressed air 70-100 psi (5-7 bar) to the “Main Air In” port on the
back of the machine.
10.
If the “Spray Air Out”, “Dispense Air Out” or “Main Air Out” ports on the back of the
machine are not required for the dispense equipment set-up onto the machine; then a
blanking plug provided in the accessories bag must be inserted into the port(s).
11.
Insert appropriate country type power chord into the power supply, and then connect to
the power input connector on the back panel of the machine.
12.
Tie back all electrical cables and pneumatic tubing so that they do not interfere with the
machine motion when in operation.