FISNAR F1300N.2, Operating Manual

Page: 21 / 64

F1300N.2 Rotary Table Operating Manual
© 2022 Fisnar - 21 - F1300N.2 Rev 01
1
E-Stop
Condition
This button is used to confirm the behavior of the Z-Axis drive cylinder
when the E-Stop button is pressed as described below.
E-Stop Up button highlighted with a green color background
If the E-stop button is pressed while the Z-Axis is moving to the “DOWN”
position or is in the “DOWN” position, it will automatically return back to
the UP position.
E-Stop Up button not highlighted. Background color is gray.
If the E-stop button is pressed while the Z-Axis is moving to the “DOWN”
position or is in the down position, it will continue to or remain in the
“DOWN” position.
2
Firmware
Version
Displays the firmware version installed onto the machine.
3 Total ON Time
Displays the total number of minutes the machine has been switched on
for. This counter is not resettable.
4 Total Cycles
Displays the total number of completed cycles made by the machine. This
counter is not resettable.
5 Motor Acc. Time
Sets the time it takes for the motor to reach the RPM value set in the
production screen. The time is set in milliseconds. The higher the value
the longer the time of reaching the set RPM. When dispensing onto a
heavy workpiece a longer time is needed to prevent damage to the motor.
Times can be set from 50ms – 999ms.
The Default value is set at 50ms.
6 Motor Rotation
Sets the rotation of the motor on the machine.
CW = Clockwise
CCW = Counterclockwise
7
Auto Cycle
Delay
Auto cycle is enabled as soon as a value greater than “0” seconds is
entered.
The time entered is the delay time between one cycle ending and the next
one automatically starting.
When Auto Cycle Delay is set at 0.0 seconds Auto cycle is disabled.