5.
Lift out the solid state relay. Put new solid state
relay in place, making certain that the thin, con-
ductive pad remains between the solid state
relay and the bezel.
6.
Generally reverse the steps above to reassem-
ble oven.
Replacing the Safety Relay
To replace a defective safety relay, proceed as follows:
1.
Complete the procedures discussed in
Accessing the Electronics Compartment
,
observing all caution statements.
2.
Consult the schematic and locate the safety
relay (mounted on Bezel, see Fig. 3).
3.
Remove four lead wires from their push-on ter-
minals.
4.
Remove two Phillips screws, which mount the
safety relay to the bezel.
5.
Lift out the safety relay.
6.
Generally reverse the steps above to install the
replacement safety relay and reassemble oven.
Replacing the Thermocouple
To replace a defective control thermocouple, proceed as
follows:
1.
Complete the procedures discussed in
Accessing the Electronics Compartment
,
observing all caution statements.
2.
Remove thermocouple wires from push tab ter-
minals on back of controller.
3.
On roof of oven, locate clip which holds thermo-
couple in place. Remove thermocouple from
clip.
29
S
ERVICE
Summary of Contents for Isotemp 800 Series
Page 34: ...34 Schematic Diagram...
Page 35: ...35...
