background image

16

Consumer Information

Información al consumidor

FCC Statement (United States Only)

This equipment has been tested and found 
to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide 
reasonable protection against harmful 
interference in a residential installation. 
This equipment generates, uses and can 
radiate radio frequency energy and, if not 
installed and used in accordance with the 
instructions, may cause harmful interference 
to radio communications. However, there is 
no guarantee that interference will not occur 
in a particular installation. If this equipment 
does cause harmful interference to radio or 
television reception, which can be determined 
by turning the equipment off and on, the user 
is encouraged to try to correct the interference 
by one or more of the following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the 

equipment and receiver.

•  Consult the dealer or an experienced 

radio/TV technician for help.

Note:

 Changes or modifications not 

expressly approved by the manufacturer 
responsible for compliance could void the 
user’s authority to operate the equipment.
This device complies with Part 15 of the 
FCC Rules. Operation is subject to the 
following two conditions: (1) this device 
may not cause harmful interference and 
(2) this device must accept any interference 
received, including interference that may 
cause undesired operation.

Nota FCC (Válido sólo en los Estados Unidos)

Este equipo fue probado y cumple con los 
límites de un dispositivo digital de Clase B, 
según está establecido en la Parte 15 del 
reglamento FCC. Estos límites están 
diseñados para proporcionar una protección 
razonable contra interferencia dañina en 
una instalación residencial. Este equipo 
genera, utiliza y puede radiar energía de 
radiofrecuencia y, si no se instala y utiliza 
según lo estipulado en las instrucciones, 
puede causar interferencia dañina 
a radiocomunicaciones. 

Sin embargo, no hay ninguna garantía de 
que no haya interferencia en una instalación 
particular. Si este equipo llega a causar 
interferencia dañina a la recepción de radio 
o televisión, lo cual puede ser verificado 
encendiendo y apagando el equipo, se 
recomienda tomar una de las siguientes 
medidas para corregir el problema:
•  Cambiar la orientación o localización de la 

antena receptora.

•  Aumentar la distancia entre el equipo 

y el receptor.

•  Ponerse en contacto con el distribuidor 

o con un técnico de radio/TV.

Nota:

 los cambios o modificaciones no 

expresamente autorizados por el fabricante 
responsable del cumplimiento de las 
normas puede cancelar la autoridad del 
usuario de usar el equipo.
Este dispositivo cumple con la Parte 15 del 
reglamento FCC. El uso está sujeto a las dos 
condiciones siguientes: (1) Este dispositivo 
no debe causar interferencia dañina y (2) este 
dispositivo debe aceptar cualquier interferencia 
recibida, incluyendo interferencia que 
pueda causar que el dispositivo no 
funcione correctamente.

ICES-003

•  This Class B digital apparatus complies 

with Canadian ICES-003. Operation is 
subject to the following two conditions: 
(1) this device may not cause harmful 
interference and (2) this device must 
accept any interference received, including 
interference that may cause 
undesired operation.

NMB-003

•  Cet appareil numérique de la classe B est 

conforme à la norme NMB-003 du Canada. 
L’utilisation de ce dispositif est autorisée 
seulement aux conditions suivantes: 
(1) il ne doit pas produire de brouillage et 
(2) l’utilisateur du dispositif doit être prêt 
à accepter tout brouillage radioélectrique 
reçu, même si ce brouillage est susceptible 
de compromettre le fonctionnement 
du dispositif.

Summary of Contents for X7046

















Reviews: