SAFEAIRE
®
LABORATORY FUME HOODS
OPERATION, MAINTENANCE AND INSTALLATION INSTRUCTIONS
INSTALLATION
5
Dimensions are nominal and illustrations and specifications are based
on the latest product information available at the time of publication.
The right is reserved to make changes at any time without notice.
1. Attach left-hand side assembly (2) to back assembly (1).
Take back panel assembly and stand vertically, as shown,
and slide into end assembly. (Angle flange of end assembly
fits between back panel and horizontal members of back
assembly). Secure each corner with two #8 X 5/8" PPHSMS
at mating holes on top and bottom corners of joined
assembly. Repeat steps with right-hand end (3). Attach each
baffle support with two each #8 X 3/4" PPHTCS through
back panel into support. Do not over-tighten.
#8 X3/4" PPHTCS
#8 X5/8" PPHSMS
1
2
1
2
ASSEMBLY INSTRUCTIONS FOR KNOCKED-DOWN
FLOOR-MOUNTED FUME HOODS
General - When receiving fume hood assemblies, inspect for
damage immediately. If damage is noted, request the delivering
carrier to note and describe damage on bill of lading prior to
your signature. Notify carrier immediately and request
inspection.
Open boxes and crates and examine for hidden damage. If
damage is noted, save containers and request an inspection.
Move all components to installation area.
2. Attach top assembly (4), as shown at left, to
back and ends with eleven (11) #10 X 5/8"
PPHSMS. Top assembly fits underneath right-
hand rear pulley bracket assembly. Secure
exhaust collar to rear rail.
#10 X5/8" PPHSMS
2
TOP
BACK
REAR PULLEY
BRACKET ASSEMBLY
Summary of Contents for SAFEAIRE series
Page 1: ......