Lit. No. 72446, Rev. 05
96
November 15, 2020
MAINTENANCE
5. Raise and lower the blade several times. The
cutting edge should contact the level surface
across the full length of the cutting edge.
6. Verify that the cutting edges remain in full
contact with the ground while the wings are
shifted from the scoop position to a retracted
(vee) position.
Complete this procedure as often as required
to provide even cutting edge wear. Replace the
cutting edge(s) on your XtremeV™ or XV2™ blade
when worn to within 1" of the carriage bolts.
GREASING PIVOT PIN HINGE
For XV2 and EZ-V
®
Snowplows:
Using a
rubber-tipped seal-off coupler, apply a good
quality multipurpose grease at the five grease
points along the center pivot pin hinge.
Grease the hinge at the beginning of the
snowplow season. Reapply as needed during
the season and before putting the snowplow
in storage.
Grease
Points
