18
ELECTRICAL / GAS CONNECTIONS
CAUTION:
The appliance must be isolated from the building’s gas supply piping system
by closing its individual manual shut-off valve during any pressure testing of
the gas supply piping system at test pressures equal to or less than 1/2 psig
(3.5kPa.).
The appliance and its individual shut-off valve must be disconnected from the
gas supply piping system during any pressure testing of the system at the test
pressures in excess of 1/2 psig (3.5kPa.). When checking the manifold gas
pressure, the inlet pressure to the regulator should be at least 7.0” W.C. for
natural gas or 12.0” for LP.
WARNING
:
For Warranty coverage, DCS requires
that burner adjustments be made by a
qualified technician at the time of
installation. Extreme care should be
used when adjustments are made
after installation.
Note: No air shutter adjustment is possible on the top
burners.
SEALED TOP BURNER LIGHTING NOTE:
The sealed top burners have an infinite number of heat settings and there are no fixed positions on
the control knobs between HI and LO. To turn the sealed top burner on, push in on the control knob
and turn it counterclockwise to the “LITE” position. An audible clicking sound will be heard. When the
gas has been ignited by the electronic spark igniter, turn the knob to the desired setting.
WARNING:
When turning on any sealed top burner, be sure to stop at the “LITE” position
before turning the burner to a flame setting for cooking. If the burner is not lit
and it is turned beyond the “LITE” position, to HI, MEDIUM, or LO, there will be
a burst of flame when the burner does light. This could cause burns or damage
to the surrounding countertop.
TEST AND ADJUSTMENTS
1-1/2"
COOKTOP BURNER
FIG. 15
Summary of Contents for DCS RGS Series
Page 24: ...23 NOTES...
Page 25: ...NOTES 24...
