Maintenance Instructions
10.5.11
Panda 8000-42NE PVMV-N.R01 - Kapitel/Chapter 7: Maintenance Instructions Seite/Page 85
7.3
Environmental protection
Environmental protection.
Danger to the environment due to mishandling!
Significant environmental damage can occur, particularly for incorrect dispo-
sal, if environmentally hazardous operating materials are mishandled. The-
refore:
– Always observe the instructions mentioned below.
– Take immediate action if environmentally hazardous materials reach the
environment. Inform the responsible local authorities about the damage in
the case of doubt.
The disposal must be performed by a specialist disposal company.
7.4
Maintenance Requirements
Control before starting
• Oil level
• Cooling system leaks
• Visual check for any changes, leaks oil drain system, v-belt,
cable connections, hose clips, air filter, fuel lines
Once a week
• Lubrication of actuator-trapezoid thread spindle
7.5
Oil Circuit Maintenance
The laid down intervals must be heeded in order to avoid serious damage to the motor!
The first oil change should be carried out 35 hours after running time. Thereafter every 150 hours.
SAE 30 is to be used for temperatures over 20°C and SEA 20 for temperatures between 5°C and 20°C. Visc osity
SAE 10W or 10W-30 is laid down for temperatures below 5°C.
Type and amount of required oil see: Table 9.8, “Technical
Data,” on Page 123
Fig. 7.5-1: Oildrainhose
Oildrainhose
An oil drainage hose is fitted in the sound cover for changing the oil. This is
fed through the capsule to the outside.
Open the pass-through cover at the sound cover for the oil drain hose.
representative picture
