Firstech technical support is reserved for authorized dealers only.
Monday - Friday
888-820-3690
(7:00 am – 5:00 pm Pacific Coast Time)
Web
http://www.firstechllc.com/ft820
W
ire
D
iagrams
Click on the “Installogy Access Client” link found on your
desktop. If you are a qualified dealer and unable to access this
site, call your sales representative or the number above.
Frequently Asked Questions
I have everything hooked up and the system will not respond.
A: The remotes need to be programmed. Review the “Remote Programming Procedure” above.
What is the green loop wire outside the brain module?
A: This wire determines the transmission mode. With the loop intact, the system is set for manual transmissions.
With the loop cut, the system is set for automatic transmission.
The vehicle remote starts when disarmed, but not when armed.
A: The starter kill relay was installed backwards. Check to make sure the yellow/black wire is going to the ignition
side of the wire, and that the yellow wire is going to the engine side.
The vehicle starts and shuts down 3 times in a row.
A: This usually means that the engine sensing mode is not working correctly. Also check the transponder bypass for
the vehicle as well.
The vehicle will lock and unlock, but will not remote start or flash the parking lights.
A: The system is in valet mode. Tap buttons (I) + (III) for 0.5 seconds while the key is in the on position.
The siren chirps once every 10 seconds after I arm the system.
A: There is a poor connection between the FT820 and the vehicle’s OBDII plug. Recheck your wire(s) connection.
T
eCHnICal
s
uppoRT
C
onTaCTs
fT-820
f
RequenTly
a
sKed
q
uesTIons
fT-820
Copyright 2009 Firstech, LLC.
Page 16
fT-820 I
nsTall
G
uIde
H
yundaI
/ K
Ia
R
emoTe
s
TaRT
and
a
laRm
www.firstechllc.com /ft820 | www.compustar.com/ft820
