Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those two flashes the parking lights will flash again corresponding to the error table below:
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running or must program tach before 1st remote
start
2
Key in ignition on position
3
Door open (manual transmission only)
5
Foot brake on
6
Hood open
7
Reservation off (manual transmission only)
8
Tach or tachless sensing failure
9
DAS sensor shutdown
10
System is in Valet Mode
2 Way remotes will display the error number “Strt Er##” on the LCD.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle’s parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the
shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Resetting to Factory Defaults: To reset the options in a particular menu, enter the menu using your remote.
To reset options with a 2 Way remote tap the Trunk button 3 three times. To reset options with a 1 Way
remote tap the Key/Start button 3 times. Wait for parking lights to flash and/or siren chirp between each
tap. After the third tap, the menu will reset back to default. This must be done for each option menu that
must be reset.
STEP 2:
Scroll through menu waiting for 1 parking light flash and/or siren chirp per line.
STEP 3:
Once finished scrolling through menu, wait for the parking lights and/or siren chirp to confirm the
option number. i.e. option 2-04 will flash and/or chirp 4 times. Select your option using the Lock, Unlock,
Trunk, or Start buttons.
Troubleshooting
Copyright 2014 Firstech, LLC.
Page 3
Copyright 2014 Firstech, LLC.
Page 3
Copyright 2014 Firstech, LLC.
Page 51
CM7200
Master Guide
Starter System
techfeed.compustar.com
