4-10
PIC 4 (+):
(Programmable input Channel 4 CN5 pin 14 Pink) this feature will determine the input
function of PIC4.
FO1 - Trigger start input:
This option will enable PIC4 to be used as a trigger for activating the
remote start function using a (+) pulse input on the Pink wire CN5
FO2 - Closed Loop:
This option will enable PIC4 to be used as a closed loop input to trigger the
CM7 full alarm. This input should see ground when the CM7 is armed. (to complete the ground
circuit), then either see B+ or ground removed (which opens the ground circuit) to trigger the full
alarm.
FO3 - (+) keysense input:
this option will operate as a key sense INPUT to the CM. When used
with manual transmission, keysense input will keep the CM from completing reservation mode as long
as the input is present. In addition the keysense input will keep the system from passively arming or
EZGO proximity locking as long as the input is present.
4-11
UART port 2 protocol:
This feature will determine the communication protocol of the gray UART
port.
FO1 - Drone:
(default) This option will allow the grey UART port to communicate using the Drone
data protocol.
FO2 - Fortin:
This option allows the grey UART port to communicate using the Fortin data protocol.
Note: there is no longer an “auto detect” feature with the Fortin protocol it must be changed
manually.
4-12
Impact sensor:
This feature will determine the impact sensor input port function.
FO1 - DAS:
(default) This option allows the impact sensor port to communicate with the DAS
including sensitivity programming and monitor any sensor output to the CM7.
Note: This option is
required when using with a manual transmission vehicle.
FO2 - Standard Shock:
This option allows the CM7 to communicate with the FT-Shock analog
shock sensor. This impact sensor is manually adjustable on the sensor.
FO3 - Arm/Disarm input:
This option allows the impact sensor port (red) to be used as a CM7
arm/lock and disarm/unlock input.
Note: the arm input requires 2 pulses to trigger arm/
lock and 1 pulse to disarm/unlock.
FO4 - Arm/Disarm input:
this option allows the impact sensor port (red) to be used as a CM7
arm/lock and disarm/unlock input.
Note: the arm input requires 1 pulse to trigger arm/
lock and 1 pulse to disarm/unlock.
4-13
Antenna power save:
this will allow the CM7 to reduce overall current draw of the system when
armed by powering down the antenna.
FO1 - Off:
(default) antenna will operate normally when armed.
FO2 - 24hrs (1 day):
this option will allow the antenna to power down 24hrs after being armed.
Note: once the antenna has powered down, 1 Way operation to the vehicle will stop.
2 Way operation will still function incase any alerts are sent to the remote. In order to
wake up the antenna the user must unlock/disarm using a Firstech accessory, power
ignition or trigger the alarm.
Copyright 2014 Firstech, LLC.
Page 3
Copyright 2014 Firstech, LLC.
Page 3
Copyright 2014 Firstech, LLC.
Page 44
CM7200
Master Guide
Starter System
techfeed.compustar.com
