- 7 -
♦
Lift up the tray latch, then pull out the tray:
2.
Attach the hard drive to the tray
♦
Place your hard drive on a flat surface with the printed circuit board facing up:
♦
Position the tray over the hard drive and align the four screw holes on the drive to the
countersunk screw holes on the tray. The connectors on the back of the hard drive
must be aligned with the back of the tray (to the right in the picture below):
♦
Attach the hard drive to the tray with the four supplied countersink-type screws (do
not over tighten):
Important:
Exposed hard
drive connectors
should be flush
with the tray on
this end
Lift and Pull
