22
INSTALLING THE DISPLAY MODULE
Slide the bottom of the ED510 display onto the two (2) mounting tabs on the face of the EP113 programmer.
Tilt the ED510 display towards the cover until the mounting tab on top of the ED510 display snaps into position into the
opening on the face of the EP113 programmer.
Install the ED580 cable (provided) into the RJ-style connectors on both the ED510 display and EP113 programmer.
INSTALLING THE CONTROL
CAUTION: ELECTRIC POWER MUST BE TURNED OFF DURING INSTALLATION.
FIELD WIRING
The use of 2.5mm
2
wires, rated at 600V is appropriate for all field wiring. The wiring base is pro-
vided with eighteen (18) numbered terminals plus an earthing screw.
1.
Check the electrical tabs on the bottom of the chassis – if
they are bent out of position, reposition them with your fin-
gers so they are in line as shown here.
2.
Slide the slots at the bottom of the assembled control over the
tabs on the wiring base. Push the control into position. Insert a
screwdriver through the hole in the top of the control and
tighten the retaining screw.
3.
Electric power may now be turned on.
