21
®
INSTALLATION INSTRUCTIONS
CONTROL INSTALLATION
The control must be assembled before plugging it into the wiring base. When replacing modules, the
control must be removed from the wiring base.
CAUTION: Electrical power must be turned off during installation.
To remove the cover place your fingers and palms on each
side and pull toward as shown in the diagram. Press down
with thumbs while pulling out with your palms and fingers.
The cover will snap off and can be snapped back into place
easily.
INSTALLING AMPLIFIER MODULE
The flame amplifier module is installed in the third set of
guide channels found in the EB720 and EB721 FLAME-
MONITOR chassis. It is marked “AMPLIFIER MODULE.”
Do not force the module into position.
INSTALLING PROGRAMMER MODULE
Fireye FLAME-MONITOR Programmer Modules are used
with Fireye Series EB720 or EB721 base chassis. To install,
simply insert the module into the second slot on the control
(marked “Programmer Module” on the side of the chassis.
Programmer Modules only fit in the proper slot. They cannot
be snapped into place if inserted in the wrong location. DO
NOT FORCE THEM.