2
vi30/40 Dual Cooled QSG Version 2.1
Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide
Readying your Laser for use:
3.
Failure to remove the aperture seal can damage your system!
(Fan-Cooled ti60 Shown)
AVOID EXPOSURE
Invisible laser radiation
is emitted from
this aperture.
APERTURE
SEAL
SHUTTER
SWITCH
LASER EXIT
APERTURE
DP POWER
CONNECTOR
OPTICAL
ACCESSORY
MOUNTING (x6)
Consult the factory for further mounting angle guidance outside >75% from the horizontal. When mount-
ing the laser to a baseplate, use only one metric or SAE fastener per mounting tab on the baseplate. Do not
use any type of jackscrew arrangement as this will twist the baseplate and may distort the tube.
Important
Note:
SYNRAD does not recommend mounting lasers in a vertical, (head and/or tail down)
position.
Please contact the factory for limitations as a vertical orientation increases the risk
of damage to the lasers optics.
Failure to
remove can
damage the
laser!
Note:
IF using the FH Flyer marking head with your laser, go to the
Mounting & FH Flyer Quick Start Guide
and reference the
located on our website.
Note:
IF not using a SYNRAD marking head OR mounting kit with your laser, see the section below.
Laser Unpacking (Continued):
