3
vi30/40 Dual Cooled QSG Version 2.1
Firestar™ vi30/40 Dual Cooled Laser Quick Start Guide
Mounting:
4.
Locate the
Mounting Hardware
( ).
Note:
Three ball bearing “feet” pressed into Firestar’s base plate eliminate any possible distortion of the
laser tube caused by variations in the flatness of the mounting surface.
5.
Choose your mounting type.
A.
Standard Mounting (smallest footprint):
B.
Tall Mounting (matches v30 height-for upgrading from v30 to vi30/40 for mounting from below):
The ‘Tall’ mounting kit (SYNRAD® P/N 250-20190-01).
C.
Tall/Wide Mounting (matches v30 height-for upgrading from v30 to vi30/40 for mounting from
above):
The ‘Tall/Wide’ mounting kit (SYNRAD P/N 250-20190-02).
6.
Standard Mounting: Drill three thru holes in the final mounting surface that correspond to either the
ISO (metric) or UNC fastener pattern shown in the O&M drawings located on our
7.
Insert the three M6 × 1 ISO or 1/4–20 UNC fasteners through the mounting surface into the
corresponding threaded holes Evenly tighten all capscrews to a maximum torque of 6.1 Nm (54 in lb).
Front
Back
4.1
Standard Mounting Dual cooled with fans shown (vi30 shown).
Caution
Possible Equipment
Damage
When mounting from below, mounting bolts must not extend further
than 6.0 mm (0.24 in) into the base plate. Otherwise damage to the laser
may occur.
