Firepower TIG 200 AC/DC, Operating Manual

Page: 45 / 80

INSTALLATION FIREPOWER TIG 200 AC/DC
Manual 0-5370 3-17
Installation
7. Relief Valve (where provided): The relief valve is designed to protect the low pressure side of the Flowmeter/
Regulator from high pres sures. Relief valves are not intended to protect down stream equipment from high
pressures.
!
WARNING
DO NOT tamper with the relief valve or remove it from the Flowmeter/Regulator.
!
WARNING
Stand to the side of the cylinder opposite the Flowmeter/Regulator when opening the cylinder valve.
Keep the cylinder valve between you and the Flowmeter/Regulator. For your safety, NEVER STAND IN
FRONT OF OR BEHIND A Flowmeter/Regulator WHEN OPENING THE CYLINDER VALVE!
8. Slowly and carefully open the cylinder valve (Figure 3-9) until the maximum pressure shows on the high
pressure gauge.
Art # A-09828
Figure 3-9: Open Cylinder Valve
9. Open the cylinder valve completely to seal the valve packing. On gaugeless Flowmeter/Regulators, the
indicator will register the cylinder contents open.
CAUTION
Keep the cylinder valve wrench, if one is required, on the cylinder valve to turn off the cylinder quickly,
if necessary.
10. Attach the desired downstream equipment.
3.13 SPECIFICATION FOR TIG TORCH
1. SPECIFICATION FOR TIG TORCH PART NO: W4013600 TO SUIT Firepower 200AC/DC
TIG Torch Contents include:
1 x 26 TIG Torch with Long Back Cap, 12.5 ft lead length, 10.5" gas hose length, 9.5" control lead with 8 pin
plug and Rigid Head.
Remote Control Cartridge, Potentiometer with integrated on/off switch (installed).