Firepower TIG 200 AC/DC, Operating Manual

Page: 38 / 80

FIREPOWER TIG 200 AC/DC INSTALLATION
3-10 Manual 0-5370
Installation
19. Digital Voltmeter / Parameter meter
The digital volt meter is used to display the actual output voltage of the power source. It is also used to display
Parameters in Programming Mode.
Depending on the Programming Parameter selected, the status indictor adjacent to the volt meter will illuminate
to show the units of the programming parameter.
When welding, the volt meter will display actual welding voltage.
20. ON / OFF Switch
This Switch is located on the rear of the Power Source and turns mains power off and on.
!
WARNING
When the front digital displays are lit, the machine is connected to the Mains supply voltage and the
internal electrical components are at Mains voltage potential
21. Shielding Gas Inlet
Unit has a 5/8" Inert gas fitting suitable for connection of a gas hose to a regulated Shielding Gas Supply. The
Shielding Gas inlet is located on the rear of the Power Source.
22. Cooling Fan
The 200 AC/DC is fitted with a cooling fan that will operate continuously when the ON/OFF switch on the rear
panel is switched to the ON position.
3.09 200 AC/DC - STICK PROGRAMMING MODE
Press the PROCESS SELECTION button to select STICK mode.
Press the MODE switch to toggle between AC and DC welding output.
Press FORWARD or BACK to cycle through available programming functions.
Use the Multi Function Control to adjust the Parameter selected.
While welding the Multi Function Control directly controls the WELD CURRENT.
Adjust programming parameter Press to go forward / go back between
programming status LED’s
A-12716
Figure 3-5: Stick Programming Mode