84
4
OPERATION AND USE
id.:
D 70 SL REV. 00 02/11/2009
4.9.1 CORRECT USE OF THE VEHICLE
During road transfer, the operator should keep the driving post turned toward the front of the machine. When
driving on public roads, follow the specifi c safety regulations as set out in chapter 3.
During work on a site, preferably drive the vehicle as you would during road transfer. However, depending on
the operation you need to carry out or if you are in particular conditions where you cannot reverse, the driving
post may be used facing the rear (alternative working phase).
To unload material into a trench it is advisable to use the driving post facing the rear.
CAUTION: Always have someone on the ground assist you when you carry out operations in the
working phase.
Before using the vehicle, you must perform some safety checks.
Some of these checks are aimed at verifying proper vehicle operation, others involve your own safety.
Have any and all defects or malfunctions repaired by a mechanical engineer.
Before performing all checks, make sure that the parking brake is applied.
Cleanliness
- Clean the windows, lights and rearview mirrors.
NOTE: Check that the rearview mirrors are positioned so that you have the best possible visibility of the area
behind the vehicle.
- Remove grime and dirt from the pins and the radiator.
- Make sure that the steps and handhold are clean and dry.
- Clean all the adhesive safety labels. Replace any illegible or missing labels.
Damage
- Check that there are no damaged or missing parts.
- Check that all the articulation pins are properly in place and lubricated.
- Check the windows for any cracks or damage.
- Check that there are no oil, fuel or coolant leaks underneath the vehicle.
Check all the devices as indicated in the scheduled maintenance table in chapter 5 and make any necessary
repairs.
4.9.2 BEFORE GETTING ON THE VEHICLE (CHECKS AND WARNINGS)
CAUTION: Before proceeding, always read the safety regulations for the operations to be carried out
as set out in Chapter 3.
When working on slopes, take some precautions to prevent risks to yourself and others in the vicinity. Carry
out the following checks and operations:
- Always check the working area for snow, small landslips, gravel and tilled soil which may suddenly change
the working conditions and vehicle stability.
Maximum surmountable gradient when loaded (ramps, obstacles, jerking).................................... 22,5° (40%)
Maximum permissible gradient on steep roads during transfer:
front .................................................................................................................................................... 25° (45%)
Side .................................................................................................................................................... 10° (18%)
4.9.3 CORRECT USE ON SLOPES
D 70 SL REV. 01 02/01/2012
Summary of Contents for D 70 SL
