26
3
SAFETY PRECAUTIONS
id.:
D 70
SL REV. 00 02/11/2009
3.1.7
PROHIBITION TO TRANSPORT PERSONS OR OBJECTS
- The vehicle is not homologated for transport of persons other than the operator, who must be seated on the
driver’s seat.
- During all working phases, do not allow anyone to come close to the vehicle.
- Do not allow anyone to climb onto the working equipment.
- Do not carry people onboard the vehicle.
- Do not use the vehicle to transport objects, except those needed for the job and equipped with special
couplings.
- Do not use the vehicle as platform or scaffolding and under no circumstances use it for any function not
specifi ed by the manufacturer.
3.1.5 SAFETY DEVICE CHECKS
- Check that all the safety devices are properly installed and that they function properly and are undamaged.
- If any irregularities are found make the appropriate repairs.
- Incorrect use of the safety devices may cause serious accidents with the consequent risk of injury or death.
- Make sure that you use the safety devices correctly.
3.1.6 PRECAUTIONS WHEN USING ACCESSORIES
- During installation of optional components or equipment, problems may occur that put your safety at risk.
Therefore, always ask FIORI for advice before installation.
- FIORI is not responsible for injury, accidents or faults deriving from use of unauthorised equipment or
accessories.
- Before installation and use of accessories, read the instruction manual of the specifi c accessory and the
general information on accessories given in this manual.
3.1.4.a Vibration level on the “operator’s body” measured on the driver’s seat
Based on measurements made in operating conditions on vehicles similar to this one, it is declared that the
mean level of vibrations on the “operator’s body” is equal to .............................................................. 1 m/sec²
This value is to be understood as RMS, weighted using the “broadband” method in compliance with ISO 7096
and ISO 2631-1 and determined according to a cycle indicated in ISO 25398 with attribution of the times
established by the company according to what are considered customary and probable vehicle operating
conditions.
3.1.4.b Vibration level on the “hands/arms” measured on the steering wheel.
Based on measurements made in operating conditions on vehicles similar to this one, it is declared that the
mean level of vibrations on the “hand/arms” is less than or equal to ................................................ 2.5 m/sec²
This value is to be understood as RMS, weighted using the “broadband” method in compliance with ISO 2631-
1 and determined according to a cycle indicated in ISO 25398 with attribution of the times established by the
company according to what are considered customary vehicle operating conditions.
3.1.4 VIBRATIONS’ LEVEL
Summary of Contents for D 70 SL
