65
4
OPERATION AND USE
id.:
D 70 SL REV. 00 02/11/2009
4.2.2.b Hour counter/revolution counter
(fi g. 5)
4.2.2.c Maintenance schedule
(fi g. 5)
When turning on with the ignition key in position 1 (vehicle power), the instrument panel runs a brief test turning
on all the segments of the display after which the instrument panel warning lights will show the vehicle status.
Subsequently, at the bottom of the numerical display (
18
), the hours remaining until the next service is due
are shown for 5 seconds. These are immediately followed by the actual total hours of vehicle operation, again
shown for 5 seconds, after which the engine rpm are shown.
The operating hour counter (
18
) cannot be reset. The hours of operation are totalled correctly only if the engine
is running at a speed of more than 200 rpm. Counting does not depend on the number of engine revolutions,
but only on the time that has actually elapsed.
In case the warning light (
1
) stays on, it means that it is almost time to do maintenance to the machine (the
warning light indicates this event about 20 hours before the deadline set by FIORI).
The preset service interval is every 500 hours. Therefore, the warning light will
fl ash
after 500, 1000, 1500,
2000, ... hours.
Once the vehicle has been serviced, the fl ashing warning light can be reset and the counter reset to start the
countdown to the next service.
To reset fl ashing, hold the reset button (
E
) on the driving post instrument panel pressed down for 20 seconds.
After 20 seconds the word “RESET” will appear on the display and the warning light (
1
) will come on. To reset
the counter, release the button
E
and press it again for another 2 seconds.
After the 2 seconds the new service interval will appear on the display and after another 3 seconds the panel
returns to normal display.
If you cut the power by disconnecting the battery master switch or remove the key before the operation is
complete, or you do not carry out the sequence as described above, fl ashing will not be reset.
CAUTION: It may be reset only after the pre-set due date and not before.
5
18
E
1
15
- green warning light: indicates that the direction indicators are on.
16
- illuminated tortoise: indicates that low gear is engaged.
17
- display: displays the hours of operation, fuel level, engine rpm.
D 70 SL REV. 04 06/10/2014
Summary of Contents for D 70 SL
