EN
Fillikid GesmbH | Tiefentalweg 1, A-5303 Thalgau, Austria | fillikid.at
MADE IN CHINA
Installation of the car seat Group II (15-25kg) and Group III (22-36kg)
with the three point safety belt
Step 5: Tighten the vehicle seat belt by pulling on the diagonal section and remove the slack of
the seat belt to the retractor.
If you want to release the child seat:
Step 1: Open the buckle of the vehicle seat belt and take out the vehicle seat belt from the guide
hooks of the child seat.
Main loading point
Removing and fitting of the seat cover
1. Open the buckle of the child seat and remove the harness straps and buckles.
2. Take off the headrest and seat cushion and open the buttons on the backrest. Now you can
take off the cover.
Daily care and maintenance
1. In the daily using, you need to check the wear and tear situation of the child seat.
2. The child seat should be kept in a dry, ventilated and cool place when it is not used.
3. If the child seat is dirty, you can use a wet sponge to clean it.
4. Washing instructions are listed as below:
Step 1: Remove the harness straps, buckles, headrest and seat
cushion.
Step 2: Place the child seat in the car and check if the backrest is
firmly pressed against the car seat.
Step 3: Sit your child in the car seat and place the diagonal belt
through behind the headrest and place the lap belt trough the two
„U“ guide slots of the child seat.
Step 4: Fasten the buckles of the car seat until you hear a clear
Click. Check if the buckle is locked safely by pulling the shoulders
straps upwards.
Be sure that the distance between main loading point and Cr point
must be more than 150mm.
Please contact the child restraint manufacturer if it is not like this.
