TWINFLEX
®
SRP Control Panel Engineering and Commissioning Manual
75
FIRE ALARM SYSTEM NOTICE
To Enable the Fire Alarm Control Panel Keys
You may gain access to the Fire Alarm Controls by inserting the
key turning ¼ turn or by entering any valid access code. The
‘Controls Enabled’ LED should then be illuminated. If, after
entering the code, further action is not taken,
the ‘Enabled’ LED
will turn off after 10 minutes of no activity.
To disable the Fire Alarm Controls, turn the key switch off. When disabled,
the ‘Enabled’ LED should then be
extinguished. If an access code was used, the Enabled LED will be blinking; if you perform no action on the
panel, the LED will turn off after 10 minutes of no activity and access to the Fire Alarm Controls will be disabled.
To prevent unauthorised operation, the controls should be kept disabled and the key/code kept secure
under the control of the responsible person.
To Manually Operate the Fire Alarm Sounders
Enable the controls and then press ‘SOUND ALARMS’.
To silence the alarm sounders press ‘SILENCE ALARMS’.
Following a Fire Alarm Operation
The red
‘FIRE’ LED will illuminate. The fire alarms and the internal
buzzer will operate as programmed. Take appropriate action as
defined by the emergency plan for the premises.
To silence the alarm press ‘SILENCE ALARMS’, then establish the
cause of the alarm and enter the details in the log book.
Reset any Manual Call Points which may have been operated, or if
a detector has been operated be sure that the cause of the alarm
has been removed, before resetting the system by pressing
‘RESET SYSTEM’.
Following a Fault Condition
The appropriate fault LEDs will illuminate. The internal buzzer
sound. To mute the panel buzzer
press ‘SILENCE BUZZER’.
Investigate and rectify the appropriate fault (competent persons).
Once the fault has been rectified the fault indication will clear
automatically.
Important Notes
FIRE ALARM COMPANY:
ADDRESS:
FOR SERVICE CALL: (Working hours) (Call Out)
