INSTALLATION
FIKE CORPORATION
Page 20 of 23
Expanded Enclosures Installation Guide
U.L. S2203
Revision No: 1, 11/01
Manual P/N 06-185
F.M. 3009544
10-059-1 (-2) – Cheetah Control System
10-057-1 (-2) – Shark Control System
10-058-1 (-2) – SHP Control System
1. Attach mounting plate as shown in section 5.2.
2. Attach transformer to mounting plate with standoff, washer, and screw (Detail A).
3. Attach control panel to mounting plate with standoff, washer, and nut (Detail B).
Note
: Do
NOT
install washer or hex nut on center standoff for SHP & Cheetah panel.
4. Attach keypad to enclosure door (Detail C/Shark only)
5. Wire transformer (and Shark keypad if necessary) as described in the appropriate manual.
5.4 INSTALL INTERNAL ELECTRONIC ASSEMBLIES
Wear grounding strap while installing internal electronic assemblies. Reference the appropriate control
panel manual for proper installation procedure of control equipment.
5.4.1
Control Systems
Mounting
Plate
#6-32 Hex
Nut
w/ Washer
Typ. 8 Plcs.
Back / Inside of
Enclosure
SHP
Control
Board
SHP
Assembly
Mounting
Plate
#6-32 Hex Screw
w/ Washer
Typ. 8 Plcs.
Back / Inside of
Enclosure
Cheetah
Control Board
Cheetah Assembly
Transformer Assembly
Transformer
2” Screw #6-32
w/ Washer
Typ. 4 Plcs.
Mounting
Plate
Back / Inside of
Enclosure
2” Screw #6-32
Washer
Transformer
1” F/F Standoff
Mounting Plate
Detail A
Detail B
