Reproduction forbidden without Fibocom Wireless Inc. written authorization - All Rights Reserved.
FIBOCOM FM150-NA User Manual
Page 54 of 72
Figure 3-19 LED Driving Circuit
Note:
Module internal rated current sink <10mA.The resistance of LED current-limiting resistor is
selected according to the driving voltage and the driving current.
3.6.2 WOWWAN#
The WOWWAN# signal is used to wake the Host (AP) when there comes the data request. The definition
of WOWWAN# signal is as follows:
Operating Mode
WOWWAN# Signal
SMS or data requests
Pull low 1s then pull high (pulse signal).
Idle/Sleep
High level
The WOWWAN# timing is shown in Figure 3-20:
WOWWAN#
1S
Idle/Sleep
Call/SMS/Data
Idle/Sleep
Status
Figure 3-20 WOWWAN# Timing
3.7 Interrupt Control
The FM150 module provides 3 interrupt signals, and the pin definition is as follows:
Pin Pin Name
I/O
Reset
Value
Pin Description
Type
8
W_DISABLE1#
I
PU
Enable/Disable RF network
1.8V/3.3V
25
DPR
I
PU
Body SAR detection
1.8V/3.3V
26
W_DISABLE2#
I
PU
GNSS Disable signal.Reserved
1.8V/3.3V
3.7.1 W_DISABLE
The module provides a hardware pin to enable/disable WWAN RF function, need AT+GTFMODE=1 to
enable this pin and the function can also be controlled by the AT command. The module enters the Flight
mode after the RF function is disabled. The definition of W_DISABLE1# signal is as below table:
