14
operatIon
Roller Shutter Step-By-Step Controller
This mode is enabled by setting parameter 20 to 5.
In this mode the device uses associations to control Z-Wave roller
shutter controllers (group 6) in Step-By-Step mode (alternately sends
commands for movement and stopping).
1st button – opens and stops:
• Click – open/stop,
• 2xClick – send pre-set level (set in parameter 152).
2nd button – closes and stops:
• Click – close/stop,
• 2xClick – stop.
Venetian blinds Step-By-Step Controller
This mode is enabled by setting parameter 20 to 6.
In this mode the device uses associations to control Z-Wave Venetian
blinds (with slats) controllers (groups 6-7) in Step-By-Step mode (al-
ternately sends commands for movement and stopping).
1st button – opens and stops:
• Click – open/stop,
• 2xClick – send pre-set level (set in parameter 152),
• Hold – opening slats until released.
2nd button – closes and stops:
• Click – close/stop,
• 2xClick – stop,
• Hold – closing slats until released.
7.3:
Powering modes
External supply mode
In external supply mode, the device indicates commands status and
can receive indications from the Z-Wave controller (using Indicator
CC), including Identification.
Device configuration is updated immediately.
To enable the external supply mode, make sure that the external
supply is connected and powered, then add the device to the Z-Wave
network (remove beforehand if already added).
