10
aDDIng to Z-Wave netWork
5.2:
Adding using SmartStart
SmartStart
enabled products can be added into a Z-Wave network
by scanning the Z-Wave QR Code present on the product with a con-
troller providing SmartStart inclusion. SmartStart product will be
added automatically within 10 minutes of being switched on in the
network range.
To add the device to the Z-Wave network
using SmartStart
:
1. To use SmartStart your controller needs to support Security S2
(see the controller’s manual).
2. Enter the full DSK string code to your controller. If your controller
is capable of QR scanning, scan the QR code placed on the label
on the box.
3. Power the device.
4. Wait for the adding process to start (up to few minutes), which is
signalled with yellow LED blinking.
5. Adding result will be confirmed by the Z-Wave controller’s
message and the LED frame:
•
Green
– successful (non-secure, S0, S2 non-authenticated),
•
Magenta
– successful (Security S2 Authenticated),
•
Red
– not successful.
In case of problems with adding the device, please reset
the device and repeat the adding procedure.
i
