Fiat 2016 500X, User Manual

Page: 139 / 204

- Forward Collision Warning (FCW) OFF Indicator
NOTE:
• The default status of FCW is “On
.
” This allows the system to warn you of a possible
collision with the vehicle in front of you .
• The forward collision button is located on the switch panel below the Uconnect
display
.
• To turn the FCW system OFF, push the forward collision button once to turn the sys-
tem OFF (led turns on) .
• Refer to “Electronic Speed Control ” in “Operating Your Vehicle” for further informa-
tion on Forward Collision Warning (FCW) operation and proper use .
- Liftgate Ajar Indicator — If Equipped
This indicator will illuminate when the liftgate is left ajar and not fully closed
.
- OIL CHANGE REQUIRED
Your vehicle is equipped with an engine oil change indicator system
.
The Oil Change tell-
tale and message (Oil Change Required) will display in the EVIC/DID display for approxi-
mately 10 seconds, after a single chime has sounded, to indicate the next scheduled oil
change interval
.
The engine oil change indicator system is duty-cycle based, which means
the engine oil change interval may fluctuate dependent upon your personal driving style
.
Unless reset, this message will continue to display each time you turn the ignition switch
to the MAR/RUN position for vehicles not equipped with Keyless Enter-N-Go, or cycle
the ignition to the ON/RUN position for vehicles equipped with Keyless Enter-N-Go
. To
turn off the message temporarily, push and release the MENU button . To reset the oil
change indicator system (after performing the scheduled maintenance), refer to the fol-
lowing procedure:
Vehicles Equipped With Keyless Enter-N-Go
1 . Without pushing the brake pedal, push the ENGINE START/STOP button and cycle
the ignition to the ON/RUN position (do not start the engine)
.
2 . Fully depress the accelerator pedal, slowly, three times within 10 seconds .
3
.
Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position
.
Vehicles Not Equipped With Keyless Enter-N-Go
1
.
Turn the ignition switch to the MAR/RUN position (do not start the engine)
.
2 . Fully depress the accelerator pedal, slowly, three times within 10 seconds .
3 . Turn the ignition switch to the STOP/OFF position .
NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator
system did not reset
.
If necessary, repeat these steps
.
WHAT TO DO IN EMERGENCIES
137