Position 26a
Parts are in
bag L
Position 26
Parts are in
bag L
Stop nut
M3
Stop nut
M3
Pressure spring
Collet
Collet
Servo
arm
Headless pin
3x3
Throttle pivot
post
Throttle rods
Throttle rods
Screw
3x18
Throttle-brake servo
Mount the ball-and-socket joint of the throttle rods with an M3 stop nut to
the carburetor arm. Make sure the carburetor arm can be moved easily.
Mount the servo arm with the screws which are enclosed in the servos.
Mount the M3x18 screw with the M3 stop nut through the servo arm of the
throttle-brake servos.
Push the collet, pressure spring, throttle pivot post and collet on the thrott-
le rods, press the throttle pivot post on the M3x18 screw in the same time
and mount it in the collets using M3 stop nuts and M3x3 headless pins.
Hint:
Do not tighten the M3 stop nut which is on the throttle pivot post,
the throttle pivot post needs to be moved easily. Bend the throttle rods
according to the illustration, they need to run smoothly and should neit-
her touch nor clamp in any position.
Position 27
Position 27a
Cut a sparing for the snap closure of the tank
cap into the bodyshell by using a scissors or
a model knife.
Drill a hole with approx. 8mm
for the adjustable body mount.
