Fetco E1231IN-1B123-PM000, Users Manual And Operator Instructions

Page: 11 / 30

Go to fetco.com for the latest versions of all information
Page 11 User Guide & Operator instructions P211 e0 November 2021
F Error Codes
DO NOT CLEAR ERROR CODES UNTIL ERROR IS IDENTIFIED AND CORRECTED

Contact factory or specialized personnel for error codes
Code Description Possible Cause Corrective Action
001
Software error-error on start up or
corrupted software
Improper start-up or shutdown Restart , if still fault: reload software
002
Internal flash corrupted
internal data memory malfunction
Error found in cyclic
redundancy check CRC
Restart , if still fault: reload software
If not corrected :replace board
050 Short-circuit in temperature probe Probe failure. Replace probe.
051 Open temperature probe.
Bad probe connection, or probe
failure.
Check all connections. Replace probe if
necessary.
100
Initial Fill Error.
Initial fill time took longer than
expected after powering up.
Water supply flow rate is too
low.
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter...)
101
Error on refill-.
Tank did not refill within expected
time.
Water supply flow rate is too
low.
Watch for short potting during brew
cycle. Investigate cause of low flow
rate. (Clogged water filter…)
200 Heating flatline-Tank is boiling
Heater is on, temperature is not
rising/dropping
High elevation correction. Bad heaters
or temperature probe or position
201
Heater open, high limit
thermostat, or Solid State Relay
(SSR) fault
Failure of heating element,
SSR, high limit or low voltage
Check and replace heating elements,
SSRs, high limit devices if necessary.
202 Heater Shorted or Stuck SSR
Heater is off and heating
SSR is stuck “ON”
Check that ohms range of heater are
between 10-8 0Ω ; replace if not. SSR
may be stuck in ON mode-replace SSR.
255 Keyboard [HID] error
Usually from longer than 10 sec
contact. Or faulty reassembly
after service
Restart , if still fault: reload software. If
mechanical: replace module
NO
BSKT
Insert Brew Basket
Brew basket must be in place
This is a
SAFETY FEATURE
Insert brew basket into brewer rails to
enable brewer