12
Programming- operator access programming
-The FETCO CBS-2130 brewers have four brew batch menus per side.
They are preprogrammed with basic settings that will operate the equipment as purchased.
There are two batches each marked “Regular” and two marked “Decaf”
-Most operators prefer a full batch and half batch setting for regular and decaf or specialty coffees. These will need
to be programmed by the operator
-Settings are adjustable and the names can be changed. -Batch 1 & 4 cannot be disabled.
Menu screen displayed
Accessing
Programming
Menu screen displayed
Accessing
Programming menu
screens
(FETCO “HOME” screen)
Turn unit “OFF”
After 10 second delay:
Pre-check will display:
"
DC
voltage calibration for pumps is
running…Please wait…Calibration
is successfully done”
.
Turn unit “ON”
“HOME" Screen on left will
appear
Å
Immediately place finger on
screen and “HOLD”
Screen on right will appear
Æ
<
PROGRAM
>
<
Batch 1 Left
>
EXIT
<<
>>
T
Å
Top line is programming
category
Å
Second line displays
items for programming
Right and left hand arrows
will scroll to the screens that
display
“
Program, General,
Inputs, Outputs and Other
”
.
Down arrow enters the
individual programming items
shown below
Programming-category screens: Menu Tree
Programming category screens
To enter:
Turn unit “OFF”, After 10 second delay, turn unit “ON”, (Home Screen will appear),
Immediately place finger on screen and “HOLD” PROGRAM
Screen (first below) will appear.
Use right/left and down arrows to travel through programming. “EXIT” saves settings
Programming Category
Programming Category
Programming Category
Programming Category
Programming Category
PROGRAM
GENERAL
INPUTS
OUTPUTS
OTHER
Items for Programming
Items for Programming Items for Programming
Items for
Programming
Items for Programming
Batch 1 LEFT*
Tank Temp
Display Inputs
Left Pump
Error Codes
Batch 2 Left**
Brew At Temp
Calib Touch Scr
L.Bypass Pump*
Display Errors
Batch 3 Left
**
Unit of Meas.
Right Pump
Reset Errors
Batch 4 Left
**
Volume
R.Bypass Pump*
Copy Program
Batch 1 RIGHT*
ECO Mode
Fill Valve
From SD to B
Batch 2 Right
**
Logo Timeout
Heater
From B to SD
Batch 3 Right
**
Brew B.Sensor
Screen
Upload Logo
Batch 4 Right
**
Res to Factory
Batch Copy
*
Bypass option is only on
1 gallon airpot version
Firmware
