Festo YJKP-MT, Operating Instructions Manual, Page: 27 / 32

Festo — YJKP-ST/MT — 2021-11f
Maintenance
27
3.
Port Description TCP/UDP
20, 21 FTP TCP
1024 - 65535 FTP logging
Depending on the FTP server
configuration, ports in this sec-
tion must be enabled. TCP
4444 Control of servo press via
TCP/IP TCP
502 Modbus TCP
44818 EtherNet/IP TCP
2222 EtherNet/IP UDP
10002 Festo Field Device Tool UDP/TCP
445 SMB TCP
4840, 443 OPC UA TCP
Tab. 18: Servo press controller ports
Preparation with the FFT
1. Preparation with the FFT: set network parameters of the controller CECC-X-M1-YS.
2. Set network parameters of the motor controller CMMP-AS.
Optional: update firmware and software.
–
Firmware update for controller CECC-X-M1-YS
–
Firmware update for motor controller CMMP-AS
–
Software update for servo press software on the controller CECC-X-M1-YS
Examples with explanations in the application notes from Festo
è
www.festo.com/sp.
NOTICE
Increased wear in case of operation with too little stroke.
• Observe the minimum stroke.
• If undercut: minimum stroke of 12.5 mm must be traversed 10 times in every 100 movement cycles.
9 Maintenance
9.1 Safety
WARNING
Risk of injury due to lowering piston rod.
• Before working on the product: Secure the piston rod to prevent it from lowering.