SFAM
Festo – SFAM – 2017-09c English
17
Symbol
Significance
The symbol on the display flashes (here: Out B)
Security code active (lock – blocked against unauthorised programming)
Security code inactive (Lock)
Press pushbutton (here: A pushbutton).
Press the A pushbutton or B pushbutton. The SFAM then switches to the setting
indicated by thearrow.
Press the A pushbutton and B pushbutton simultaneously
Press pushbutton (here A pushbutton) and the EDIT button simultaneously
Press A pushbutton or B pushbutton and thus set the desired value
A momentary display (here [ANA.F]) means that a value can be displayed.
Display for a value or switching point. Value can be set.
Press the Edit button
Branch in the menu
The setting last selected in the EDIT mode is indicated in the SHOW mode
Tab. 10
Symbols for representing the menu structure
5.3
RUN mode
In the basic status, the product is in RUN mode. The current measured value is displayed. The basic
status can be reached from other modes by:
–
Pressing the Edit button for 3 seconds or
–
Expiration of a monitoring time, timeout
In the RUN mode, the following are displayed:
–
the measurement values for the flow rate (in l/min or scfm)
–
the measurement values for air consumption (in m³, scf or l) and
–
the signal statuses of the switching outputs Out A, Out B (set, not set).
1. Switch on the operating voltage.
The SFAM is in RUN mode.
2. Check the SFAM settings
è
Chapter 5.4 SHOW mode.
Note
A flashing value means that the value was measured outside the permissible
measuringrange.
