Festo MPA-ASI Series, Manual

Page: 102 / 208

3. Installation
3−32
Festo P.BE−MPA−EN en 0802c
3.5.2 MPA−S valve terminal with CPI module or AS−Interface
Instructions on addressing the pneumatic modules can be
found in the leaflet supplied with the product.
3.5.3 MPA−S valve terminal with multipin connection
Assign the addresses in ascending order without gaps
(see example).
Addess assignment does not depend on whether blanking
plates or valve plates are fitted.
Depending on the electronic module, a valve location
occupies the following number of addresses:
Number of
dd
Electronic module
addresses
MPA1 MPA2
one address VMPA1−MPM−EMM− 4 VMPA2−MPM−EMM− 2
two addresses VMPA1−MPM−EMM− 8 VMPA2−MPM−EMM− 4
Tab.3/8: Electronic modules for multipin connection
If a valve location occupies 2 addresses, the following
applies:
pilot solenoid 14 occupies the lower−value address
pilot solenoid 12 occupies the higher−value address.