Festo Checkbox Compact CHB-C-C, Manual

Page: 16 / 138

Contents and general instructions
XIV
Festo P.BE-CB-COMP-EN en 0211a
Term/abbreviation Meaning
Features Characteristic features are ascertained from the contour data of the
sample and test parts. These are, e.g. length, height etc., as well as a
feature for each configuration tool (CheckOpti).
Scatter of characteristics The value range of a feature ascertained from several parts.
Sample parts Good parts selected for the teach procedure which show all features
necessary for identifying the parts type.
Orientation The parts to be checked by the Checkbox may lie in different align-
ments on the conveyor belt. During the teach procedure, you can
define the orientations by showing the different alignments.
Orientation 1 is the preferred orientation (nominal orientation).
(System) parameter Checkbox settings (in some cases settings can only be made with
configuration software)
Test data The test data are the data used for the test. These correspond to the
teach data plus the specified tolerances.
Test parts All parts shown during the test process.
Test procedure During the test procedure, test parts on the conveyor belt are shown
to the Checkbox and classified according to their features with regard
to orientation and observance of tolerances. This is also referred to as
“Testing parts.”
Bad part A test part on which at least one feature lies outside the tolerances.
Teach data All features ascertained during teaching, in each case with min./max.
limits and average value.
TEACH mode Operating mode of the Checkbox in which the teach procedure is
carried out.
Parts type Conveyed part defined by the teach data of the sample parts.
Tolerance Factor in percent related to the average values and which has an effect
on the min./max. limits of all the features.