25 / 36
Festo 7ADN-KP_ADN-ELa_en
•
To protect the bearing and seals, place the appropriate mounting sleeve
(see chapter
9.2 "Special tools"
) on the thread of the piston rod to prevent
damage.
•
Insert clamping unit KP in the location hole of the cover.
Note
The piston rod can only be pushed through clamping unit KP if the clamping is released.
•
To insert the piston rod, pressurise the compressed air connection of the
clamping unit KP
1
(3 to max. 10 bar) or insert a screw (M5 or G1/8) into
the thread for the compressed air connection
2
until the clamping is
released.
2
3
1
•
Guide the cover with clamping unit KP over the mounting sleeve (see
chapter
9.2 "Special tools"
) onto the piston rod as far as the cylinder barrel.
•
ADN-20 to 63-…-KP
–
Align the cover with clamping unit KP flush with the cylinder barrel.
– Apply the screw locking agent included in the set of wearing parts to the
flange screws and screw these through the cover with clamping unit KP
into the cylinder barrel.
– Tighten the screws using the appropriate torque (see table).
