26 / 36
Festo 7ADN-KP_ADN-ELa_en
– Guide the bearing cap over the mounting sleeve (see chapter
9.2 "Special tools"
) onto the piston rod as far as the cover with
clamping unit KP.
– Apply the screw locking agent included in the set of wearing parts to
the flange screws and screw these through the bearing cap into the
cover with clamping unit KP.
–
Align the bearing cap flush with the cylinder barrel.
– Tighten the screws using the appropriate torque (see table).
– Place the end cap at the other end of the cylinder barrel.
– Apply the screw locking agent included in the set of wearing parts to
the flange screws and screw these through the end cap into the cylinder
barrel.
–
Align the end cap flush with the cylinder barrel.
– Tighten the screws using the appropriate torque (see table).
Type
Torque
ADN-20-…-KP
9 Nm
ADN-25-…-KP
9 Nm
ADN-32-…-KP
27 Nm
ADN-40-…-KP
27 Nm
ADN-50-…-KP
35 Nm
ADN-63-…-KP
35 Nm
•
ADN-80 / 100-…-KP
– Guide the bearing cap over the mounting sleeve (see chapter
9.2 "Special tools"
) onto the piston rod as far as the cover with
clamping unit KP.
– Apply the screw locking agent included in the set of wearing parts to the
socket head screws and screw these through the bearing cap and cover
with clamping unit KP into the cylinder barrel.
–
Align the bearing cap and the cover with clamping unit KP flush with the
cylinder barrel.
– Tighten the screws using the appropriate torque (see table).
– Place the end cap at the other end of the cylinder barrel.
– Apply the screw locking agent included in the set of wearing parts to
the socket head screws and screw these through the end cap into the
cylinder barrel.
–
Align the end cap flush with the cylinder barrel.
– Tighten the screws using the appropriate torque (see table).
Type
Torque
ADN-80-…-KP
12 Nm
ADN-100-…-KP
9 Nm
•
Perform a functional test as per the operating instructions (enclosed with
the cylinder or can be called up on the Festo website (
www.Festo.com
)) and
commission the repaired cylinder.
