21 / 36
Festo 7ADN-KP_ADN-ELa_en
•
Only ADN-80 / 100-…-KP
– Loosen the socket head screws in the bearing and end caps and remove
them.
– Pull the bearing cap away from the piston rod.
– Remove the end cap from the cylinder barrel.
– Pull the cylinder barrel from the piston rod.
– Remove any residue of the screw locking agent from the threads of the
screws.
5.3
Removing the piston rod from clamping unit KP
Note
The piston rod can only be pulled out of clamping unit KP if the clamping is released.
•
To remove the piston rod, pressurise the compressed air connection of
the clamping unit KP
1
(3 to max. 10 bar) or insert a screw (M5 or G1/8)
into the thread for the compressed air connection
2
until the clamping is
released.
•
Pull the piston rod out of the cover with clamping unit KP.
2
3
1
•
Pull the clamping unit KP out of the location hole in the cover.
•
Clean the location hole and clamping unit KP.
Note
The entire clamping unit KP must be replaced if it is showing any damage.
•
Check the cylinder barrel and piston rod for damage.
The entire cylinder must be replaced if the cylinder barrel (particularly the
bearing surface) is showing significant damage.
