Festo 8060571, Repair Instructions

Page: 38 / 52

38 / 52 Festo 7ELCC_TB_KFb_en
15. Push the cover strip into the slot of an end cap until it stops.
16. Place the clamping plate on the cover strip and push into the slot of the end
cap.
17. Clean the grub screws (2x) to remove thread locking agent.
18. Wet the grub screws (2x) with locking agent.
19. Screw the grub screws (2x) into the end cap and tighten to the appropriate
tightening torque (

Table).
Type Tightening torque
ELCC-TB-KF-60 6 Nm ± 10 %
ELCC-TB-KF-70 6 Nm ± 10 %
ELCC-TB-KF-90 6 Nm ± 10 %
ELCC-TB-KF-110 6 Nm ± 10 %
20. Push the cover strip into the slot of the second end cap until it stops.
21. Place the clamping plate on the cover strip and push into the slot of the end
cap.
22. Clean the grub screws (2x) to remove thread locking agent.
23. Wet the grub screws (2x) with locking agent.
24. Screw the grub screws loosely into the end cap. The cover strip may not be
fixed in place.
25. Select the suitable clamping element depending on the axis size (

Table
and Chapter 8.2 on page 49 ).
Type Clamping element
ELCC-TB-KF-60 EADT-S-L5-70 (use crosswise)
ELCC-TB-KF-70 EADT-S-L5-90 (use lengthwise or crosswise)
ELCC-TB-KF-90 EADT-S-L5-90 (use lengthwise or crosswise)
ELCC-TB-KF-110 EADT-S-L5-120 (use crosswise)
26. Place the clamping element in the correct position on the cover strip.
27. Press the clamping element onto the cover strip and at the same time, push
the cover strip into the slot in the end cap.
28. Tighten the grub screws (2x) in the end cap to the appropriate tightening
torque (

Table).
Type Tightening torque
ELCC-TB-KF-60 6 Nm ± 10 %
ELCC-TB-KF-70 6 Nm ± 10 %
ELCC-TB-KF-90 6 Nm ± 10 %
ELCC-TB-KF-110 6 Nm ± 10 %
29. Move the cylinder barrel module to check whether the cover strip is firmly in
place. The cover strip may not make contact with the inside top of the slide.
30. If the cover strip undulates, push the cover strip further into the end cap.