Festo 8060571, Repair Instructions

Page: 26 / 52

26 / 52 Festo 7ELCC_TB_KFb_en
3. Pull the clamping plates (2x) at the side out of the clamping component
modules (2x).
The clamping plate can sit very firmly on the toothed belt. If necessary, drive
out carefully using a thin sheet (wood or plastic).
The sheet must be thinner and narrower than the clamping plate (

Table).
Type Maximum plate thickness Maximum plate width
ELCC-TB-KF-60
.
4 mm
.
17 mm
ELCC-TB-KF-70
.
4 mm
.
17 mm
ELCC-TB-KF-90 . 5 mm . 23 mm
ELCC-TB-KF-110
.
6 mm
.
39 mm
4. Pull the toothed belt out of the clamping component modules (2x).
5. Remove the housing
2
; to do this, push in the locking clip
1
at both ends
of the housing at the same time and pull off the housing
2
.
2
1
To pull in the new toothed belt, use adhesive tape to attach it edge to edge to the old toothed belt and pull in
(

Chapter 5.1.2 on page 27 ).
6. If the new toothed belt cannot be pulled in with the help of the old toothed
belt, pull the old toothed belt completely out of the drive head.